Caller ID Setup Instructions for Absolute Cable TV

Caller ID Setup Instructions for Absolute Cable TV

1. Power Cycle the Set top Box by unplugging the power
   cord and then plugging it back up. Wait for the box to
   reboot and them make sure the Set top box and TV are
   on and playing.
2.  Press STB button on top of remote control.
3. Using the Absolute Cable TV Remote Control (identified
   on the bottom as Amino or Entone), Press “Menu” the
   screen should look like the picture below.
                                                  
4. Press the “Down Arrow” 5 times to Highlight “Alerts” and then Press “OK”
   
5. The screen should look like the picture below.
   
6. Press “OK” and a “Check Mark” appears by “Phone”
   
7. Press “Down Arrow” to Highlight “Apply” and then Press “OK”
   
8. The screen should look like the picture below. Press “Exit” to resume watching TV.
   
9. If at any time you feel like you are not in the correct menuor have pressed an incorrect key, Press “Exit” several timesto return the TV to normal and start over with step 2.

This feature can be turned on off by following this procedure.